Hawkfighter 7 replacement motor with mounting plate & prop nuts

Just the Hawkfighter 7 motor with Killerplanes HDPE custom mounting plate and 4 screws, and the prop shaft baseplate, sleeve, washer, collar nut and locknut. If you need more parts (extension wires, motor mounting plate, ESC's, propellers, etc) please see KillerPlanes Hawkfighter Upgrade Kits Versions 4 - 7  http://www.killerplanes.com/product/dynamkillerplanes-hawkfighter-upgrade-kits. PLEASE NOTE: THE PLUGS FOR THIS MOTOR ARE NOT SOLDERED ON.  IF YOU WOULD LIKE US TO SOLDER THOSE PLUGS ON FOR YOU PLEASE SELECT THAT OPTION ABOVE.

The prop shaft stuff is to fit the Hawkfighter 7  7x7x3 prop, and other props. The custom mounting plate goes inside the back of the Hawksky motor housing with hotglue after your Hawksky motor has been removed, and the Hawkfighter 7 motor mounts to that plate

NOTE: When we install the power upgrades, we run the new motor wires a different way, which is shown in the complete Hawkfighter Power Upgrade instructions. It's far easier than the original wire routing, and completely enclosed so your plane still looks great.

ANOTHER NOTE: We do NOT advise mounting these power upgrades in an un-reinforced Hawksky- you will literally blow the wings off.